GEA FK40/390 K Maintenance Manual page 46

12 I Assembly of compressor
7
Assembly of the inserted connecting rods and pistons
Position in Parts list position: 2040
parts list
Tools: Piston ring plier, spanner SW 10
Working course
INFO
- Compress the oil scraper ring and compression ring with the piston ring plier and insert the piston into the
290, 300
cylinder liner
- Place the marked connecting rod caps onto the related connecting rods
2100
- Screw on the connecting rod caps and tighten
- Turn the crankshaft by hand. In case the crankshaft does not rotate freely check the seating of the connecting
2050
rods; if necessary, disassemble the connecting rods and carry out this step once more
2
46
Pay attention to the correct pairing of connecting rods and connecting rod caps!
Replace connecting rod cap screws or in the case of reusing put on a sticker!
1
3
15 Nm