Software Module Selection Reference; Install Rdac Under Linux - Inspur AS1100H User Manual

9.8 Software module selection reference

9.9 Install RDAC under Linux

1. Make sure that HBA card driver has been correctly loaded before installing RDAC, and
HBA card shall be a driver of non-fault switch, it is suggested to use the same HBA card in one
host, and confirm that HBA cards connected to disk array are within compatible list of AS1100H.
2. Enter STRMGR installation directory, key in the following commands under prompts, then
press Enter, to unzip source file. In the following command, <rdac-package-name> is the name of
RDAC software package.
tar –zxvf <rdac-package-name>.tar.gz
3. Switch to directory linuxrdac unzipped from RDAC source file, key in the following
commands, then press Enter.
cd linuxrdac
4. Key in the following command to clean repeated target files under the directory.
make clean
5. Key in the following command to compile module.
make
6. Key in the following command to install RDAC.
make install
7. After executing make install command, modify configuration file of boot-load program,
please refer to information output by make install command.
8. Detailed steps and other information please refer to readme.txt under linuxrdac directory.
Figure 9-1