An Unsatisfactory Drying Result - Miele WT 2789 i WPM Operating Instructions Manual

An unsatisfactory drying result

Problem
The laundry is
still damp after a
drying cycle.
The laundry is
too damp or too
dry after a drying
cycle.
When laundry is
dry it feels hard
to the touch.
There is still
water in the drum
after drying.
Possible cause
The load was too small for
the electronics to assess
the residual moisture
correctly.
The laundry has formed a
ring in the drum during the
spin because it was
distributed unevenly.
The laundry has formed a
ring in the drum during the
thermospin because it was
too damp or the spin
speed was set too high.
Warm laundry feels damp. Extend the cool down time, as
The required residual
moisture level is between
two drying levels.
Too vigorous wash action.
Not enough detergent was
used.
No fabric conditioner was
used.
There is a blockage in the
water outlet.
Problem solving guide
Remedy
In future dry small loads in a
timed drying programme.
– Turn the programme selector
to Stop.
– Open the door and loosen
the laundry.
– Start the drying programme
again using a lower spin
speed.
described in the Settings menu.
Change the drying levels as
described in the Settings menu.
Programme in gentle action
and more water.
Increase detergent dose to
prevent limescale build up in
laundry.
Use fabric conditioner in last
rinse.
Clean the drain filter and the
drain pump as described in
"Problem solving guide –
Opening the drum door in the
event of a blocked drain outlet
and/or power failure".
61