Advertisement
3
Position top frame
piece over the base
and align tension
bolts to the holes in
the base.
PART A-1
4
2 TO 5 TURNS
PAST SNUG
PART A-1
www.kurtkinetic.com | 1.877.226.7824
FRAME ASSEMBLY
NOTE: If available, Lubricate
tension-bolt threads with
chain lube, spray lube, or
light oil.
PROPERLY SEATED ELASTOMERS
Tighten both tension bolts (left) until elastomer stack
(above) is fully seated. Then add 2 to 5 full turns on the
Tension bolts. Control the side-to-side sway of the trainer
by slightly adjusting the tension bolts.
If a torque wrench is available, tighten the tension bolts to
the following specifications:
25 ft-lb (with lubricant)
35 ft-lb (without lubricant)
Adjust preferred tension from this starting point in
1/4-turn increments.
Page 5
Advertisement
