JVC XV-S62SL Service Manual page 13

Removing the pickup (See Fig.16 and 17)
1. Remove the screw I attaching the T spring (S) and
the shaft holder. Remove also the plate.
ATTENTION: When reattaching, make sure that the
T spring (S) presses the shaft.
2. Pull out the part l of the shaft upward. Move the part
m in the direction of the arrow and detach from the
spindle base.
3. Disengage the joint n of the pickup and the shaft in
the direction of the arrow.
4. Pull out the shaft from the pickup.
5. Remove the two screws J attaching the actuator.
6. Disengage the joint of the actuator and the lead
spring. Pull out the lead spring.
The spring must be under the shaft when you
install pick-up.
Removing the shaft holder / shaft
1. Remove the screw K attaching the shaft holder.
2. Remove the shaft.
T spring (S)
Pick-up
Shaft
Spring
(See Fig.18)
Pickup
Joint n
Shaft holder
I
Plate
Part l
Fig.16
J
Actuator
Lead spring
Pickup
Shaft
Fig.17
Shaft
K
Shaft holder
Fig.18
XV-S62SL
Part m
Actuator
Lead spring
1-13