JVC XV-S62SL Service Manual page 9

Removing the traverse mechanism
assembly (See Fig.4 and 5)
Prior to performing the following procedure, remove
the clamper assembly and the tray.
1. Remove the four screws B attaching the traverse
mechanism assembly.
ATTENTION: Before reattaching the traverse
mechanism assembly, pass the card
wire extending from the spindle motor
board through the notch d of the
elevator.
Removing the elevator (See Fig.6 and 7)
Prior to performing the following procedure, remove
the clamper assembly, the tray and the traverse
mechanism assembly.
1. Extend each bar e inside of the loading base
outward and detach the elevator shaft.
ATTENTION: When reattaching, first fit the two
shafts on the front of the elevator to
the slots f of the slide cam.
Shafts
Elevator
Fig.7
Traverse mechanism
assembly
Elevator
Slide cam
Slots f
B
B
Fig.4
B
Traverse mechanism assembly
Fig.5
e
Loading base
Fig.6
XV-S62SL
B B
B B
B B
Elevator
Notch d
Elevator
Elevator
e
1-9