Earlex Pro-8 Operating Instructions Manual page 11

Spray gun

Hide thumbs Also See for Pro-8:

Available languages

DOCKING THE GUN

A retractable swivel arm with locating aperture is placed on the side of the turbine. The gun can be

conveniently placed in this docking area with or without the air hose attached.

This makes for handy storage of the gun when in use or not.

SPRAYING WITH PRESSURISED PAINT CONTAINERS

Using a pressurised paint container with your Pro-8™ spray gun is very easy. All you need is the

converter 3/8" H/BARB - GUN TO P/POT (PACC74). This connector allows you to connect directly

to the pressurised paint container via the tube.-

Follow these steps to convert your Pro-8™ spray gun:

1. Disconnect the air feed tube from the side of the spray gun.

2. Remove the outlet fitting and install the blanking nut (P0062) that comes with PACC74

– 3/8" Convertor.

3. Connect the paint tube.

NOTE: Converter (PACC74) is not recommended for use with gravity version.

Outlet

fitting

Blanking

Nut

⁄

" H/BARB

Tube

Table of Contents