Earlex Pro-8 Operating Instructions Manual page 12

CLEANING INSTRUCTIONS FOR YOUR SPRAY GUN
TYPE OF MATERIAL
Water-based material
Oil-based material
BASIC CLEAN - AFTER EVERY USE & CHANGES OF MATERIAL
COLOUR
• Remove Paint Container .
• Pour any left over material back into its container so that it can be used for the future. Pull the
trigger to allow material to run out of the Pick-Up Tube.
• Pour a quantity of the respective thinners into the paint container, shake the Spray Gun lightly,
reassemble the Spray Gun, then spray this liquid through the Spray Gun. Repeat this until the
thinners being sprayed is coming through with no traces of material. Repeat this with warm
soapy water and leave to dry.
• Clean Paint Container Seal.
DEEP CLEAN - BEFORE STORAGE
• Perform basic clean
• Unscrew Air Cap Ring.
• Remove Air Cap.
• Using a 13mm spanner remove the Fluid Tip.
• Place all of these items into a container and clean, using a brush and appropriate thinners.
• Clean the inside of the body of the Spray Gun.
• Rinse gun body and all components with warm soapy water to remove trace of thinners.
• Leave the gun body and components ventilated to thoroughly dry.
• Reassemble parts.
CLEANING
Clean with water
Clean with appropriate thinners
12