Mains Connections - Manley Langevin Dual Vocal Combo Owner's Manual

Your unit has been factory set to the correct mains voltage for your country. The voltage setting
is marked on the serial badge, located on the rear panel. Check that this complies with your local
supply. The voltage changeover switch is located inside the unit in the middle of the PCB near the
power transformer. To change the voltage from 120 to 240 volts, simply remove the top cover by
unscrewing the center fixing screw and sliding the top out towards the rear of the chassis. Turn the
top of the voltage changeover switch with a firm positive action using a small flat screwdriver.
Export units for certain markets have a moulded mains plug fitted to comply with local
requirements. If your unit does not have a plug fitted the coloured wires should be connected to
the appropriate plug terminals in accordance with the following code.
GREEN/YELLOW
BLUE
BROWN
As the colours of the wires in the mains lead may not correspond with the coloured marking
identifying the terminals in your plug proceed as follows;
The wire which is coloured GREEN/YELLOW must be connected to the terminal in the plug which
is marked by the letter E or by the safety earth symbol or coloured GREEN or GREEN and
YELLOW.
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked
by the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug which is marked
by the letter L or coloured RED.
DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER CON-
NECTIONS HAVE BEEN MADE.

MAINS CONNECTIONS

EARTH terminal
NEUTRALterminal
LIVE terminal
17