Sanitizing Procedure - Manitowoc S0850M Installation Use And Care Manual

Manitowoc ice installation use and care manual ice machine s0850m
Hide thumbs Also See for S0850M:
Table of Contents

Advertisement

Maintenance

SANITIZING PROCEDURE

Use sanitizer to remove algae or slime. Do not use it to
remove lime scale or other mineral deposits.
Step 1 Set the toggle switch to the OFF position after
ice falls from the evaporator at the end of a Harvest
cycle. Or, set the switch to the OFF position and allow
the ice to melt off the evaporator.
Never use anything to force ice from the evaporator.
Damage may result.
Disconnect electric power to the ice machine (and
dispenser if applicable) at the electric switch box
before proceeding.
Step 2 Remove all ice from the bin.
Step 3 Refer to Removal of Parts For Cleaning/
Sanitizing and remove ice machine parts.
Step 4 Mix a solution of water and sanitizer.
Solution Type
Water
Sanitizer
4 gal. (15 l)
4-4
! Caution
!
Warning
Mixed With
3 oz (90 ml) sanitizer
Step 5 Use the sanitizing solution and a sponge or
cloth to sanitize (wipe) all parts and interior surfaces of
the ice machine. Sanitize the following areas:
A. Side walls
B. Base (area above water trough)
C. Evaporator plastic parts
D. Bin or dispenser
Step 6 Rinse all sanitized areas with clear water.
Step 7 Install the removed parts, restore power and
place toggle switch in the ice position.
Step 8 T o start a sanitizing cycle, move the toggle
switch to the CLEAN position. The water will flow
through the water dump valve and down the drain. The
Clean light will turn on to indicate the ice machine is in
the sanitizing mode.
Step 9 Wait about two minutes or untill water starts to
flow over the evaporator.
Step 10 Add the proper amount of Manitowoc Ice
Machine Sanitizer to the water trough by pouring
between the water curtain and evaporator.
Model
S0850M
Step 11 The ice machine will automatically time out a
ten minute sanitizing cycle, followed by six rinse cycles,
and stop. The Clean light will turn off to indicate the
sanitizing cycle is completed. This entire cycle lasts
approximately 30 minutes.
Step 12 When the sanitizing process stops, move the
toggle switch to ICE position.
Section 4
Amount of Sanitizer
5 ounces (148 ml)
Part Number 80-1560-3

Advertisement

Table of Contents
loading

Table of Contents