Replenishing The Battery Fluid - Craftsman 108.27807 Operator's Manual

Replenishing the Battery
Fluid
A poorly maintained battery will
deteriorate rapidly. Check the battery
fluid level often. The fluid level should
be kept between the upper and lower
level marks. To refill use only distilled
water. Tap water contains minerals
which are harmful to a battery.
Battery Removal –
see illustrated parts list
1. Disconnect hold down straps holding the electrical box and battery in position
and remove battery cover.
2. Remove the battery vent tube from the battery.
3. Disconnect the black (negative) battery cable first.
4. Disconnect the red (positive) battery cable next.
5. Lift the battery out of the ATV, being careful not to tip it sideways and spill
electrolyte.
Battery Installation and Connections
WARNING
To avoid the possibility of explosion, always connect battery cables in the order
specified. Red (positive) cable first; black (negative) cable last. An exploding
battery can cause serious injury or death.
CAUTION
Your ATV is equipped with a 14Amp Battery. This may not be sufficient to provide
power for optional equipment. When installing optional equipment please upgrade
your battery as necessary. Contact 1-800-643-7332 for the proper battery.
Battery terminals and connections should be kept free of corrosion.
If cleaning is necessary, remove the corrosion with a stiff wire brush. Wash with a
solution of one-tablespoon baking soda and one cup water. Rinse well with tap
water and dry off with clean rags. Coat the terminals with dielectric grease or
petroleum jelly. Be careful not to allow cleaning solution or tap water into the
battery.
52