Vehicle Break-In Period; Riding Gear - Craftsman 108.27807 Operator's Manual

10. Vehicle Break-in Period

CAUTION
Do not operate at full throttle or high speeds for extended periods during the
break-in period. Excessive heat can build up and cause damage to close fitting
engine parts.
CAUTION: Speed adjustment should be limited during the
break-in period to a top speed of 25 MPH.
The break-in period for your new ATV is defined as the first 50 hours of
operation. No single action on your part is as important as a proper break-in
period. Careful treatment of a new engine will result in more efficient performance
and longer life for the engine. Perform the following procedures carefully.
1. Fill fuel tank with fresh, clean fuel.
2. Check oil reservoir level indicated on dipstick. Add oil if necessary.
3. Drive slowly at first. Select an area which is open and will give you room to
familiarize yourself with vehicle operation and handling.
4. Vary the throttle positions. Do not operate at a sustained idle.
5. Perform regular checks on fluid levels, controls, and all important areas on the
vehicle as outlined earlier on the daily pre-ride inspection checklist found in
Section 5 "Daily Pre-Ride Inspection".
6. Don't pull loads.
7. Change oil and filter after first 20 hours or 200 miles / 320 km.

11. Riding Gear

Safe Riding Gear
ATV riding requires special protective clothing, which will make your ride more
comfortable and reduces the chance of injury.
1. Helmet – Your helmet is the most important piece of protective gear for safe
riding. A helmet can prevent a severe head injury.
2. Eye Protection – A pair of goggles or helmet face shield offers the best
protection for your eyes
3. Gloves – Off-road style.
4. Boots – A pair of strong over the calf type boots with heels, such as
moto-cross boots.
5. Clothing – To protect your body, long sleeves and pants should always be
worn. Riding pants with kneepads, a jersey and shoulder pads provide the best
protection.
.
41