Radiator Coolant Level Inspection; Transmission Oil Check - Craftsman 108.27807 Operator's Manual

1. Place vehicle on a level surface.
2. Run engine for two or three minutes until warm; stop engine.
3. Clean area around drain plug.
4. Place a drain pan beneath engine crankcase and remove drain plug.
5. Allow oil to drain completely.
6. Replace sealing washer O-ring of drain plug.
7. Reinstall drain plug and torque to 14 ft.Ibs (19N.m).

Radiator Coolant Level Inspection

WARNING
Never remove the pressure cap when the engine is warm or hot. Escaping steam
can cause severe burns. The engine must be cool before removing the pressure
cap.
To ensure that the coolant maintains its ability to protect the engine, it is
recommended that the system be completely drained every two years and a fresh
50/50 mixture of antifreeze and water be added. It is also necessary to inspect the
level of coolant in the radiator if the recovery bottle has run dry.
To add coolant, make sure the engine is cool, remove radiator pressure cap, and
using a funnel, slowly add coolant mixture as necessary through the radiator filler
neck.
NOTE: Use of a non-standard pressure cap will not allow the recovery system to
function properly. If the cap should need replacement contact 1-800-643-7332 for
the correct replacement part.

Transmission Oil Check

The transmission fill plug (1) is located
on the right side of the machine. The
transmission lubricant level should be
checked monthly or 20 hours,
whichever comes first. Transmission oil
should be changed annually. With the
ATV on a level surface, remove fill plug
and check the lubricant level. The
correct transmission lubricant to use is
SEA 80W/90 GL5 Lubricant. For the
correct fluid level see section 17
"Maintenance – Lubrication Recommendations".
Transmission Oil Changing Procedure
1. Remove the four screws on the foot well and gently pull outward for access to
67