Omr Specifications - Pitney Bowes FastPac DI425 Operator's Manual

OMR Specifications

The mark must be a solid black line between 1pt and 2pts thick
(0.014 inch [0.35mm] to 0.027 inch [0.7mm]) and at least 0.393 inch
(10mm) wide.
Each mark position must be evenly spaced and at least 0.118 inch
(3mm) apart.
An area around the marks should be kept clear from print and any
other marks that the scanner might read in error. This area is called
the clear zone.
There should be no print on the opposing face of the sheet immedi-
ately behind the clear zone.
Clear Zone
0.118 inch (3mm)
minimum pitch
1pt to 2pt
0.014 inch (0.35mm)
0.027 inch (0.7mm)
0.078 inch
(2mm)
minimum
SV61789 Rev.A
to
thick
0.393 inches
(10mm)
minimum
See diagrams on
pages 3-4 and 3-5
1.65 inches (42mm)
maximum
See diagrams on
pages 3-4 and 3-5
0.078 inch
(2mm) minimum
Note: Diagram is not to scale
OMR • 3
3-3