Cutting Aluminum Extrusion; Wood Facing - Makita LS1030N Instruction Manual

1
3
1. Crown molding stopper L
2. Crown molding stopper R
3. Base
2
1 3
1. Guide fence
2. Crown molding
3. Crown molding stopper
4. Screw
1. Vise
2. Spacer block
3. Guide fence
4. Aluminum extrusion
5. Spacer block
16
Use the crown molding stoppers (optional accessories)
001789
when cutting the corners((1) - (4) in Fig.A). Install them
2
on the base as shown in the figures.
Position crown molding with its WALL CONTACT EDGE
001560
against the guide fence and its CEILING CONTACT
EDGE against the crown molding stoppers as shown in
4
the figure. Adjust the crown molding stoppers according
to the size of the crown molding. Tighten the screws to
secure the crown molding stoppers. Refer to the table
(C) for the miter angle.
For inside
corner
For outside
corner

4. Cutting aluminum extrusion

001844
When securing aluminum extrusions, use spacer blocks
or pieces of scrap as shown in the figure to prevent
1
deformation of the aluminum. Use a cutting lubricant
2
when cutting the aluminum extrusion to prevent build-up
3
of the aluminum material on the blade.
4
5
CAUTION:
• Never attempt to cut thick or round aluminum extrusions.
Thick aluminum extrusions may come loose during
operation and round aluminum extrusions cannot be
secured firmly with this tool.

5. Wood facing

Use of wood facing helps to assure splinter-free cuts in
workpieces. Attach a wood facing to the guide fence
using the holes in the guide fence.
See the figure concerning the dimensions for a sug-
gested wood facing.
Table (C)
Position
Miter angle
in Fig. A
(1) Right 45˚
(2)
Left 45˚
(3)
(4) Right 45˚
Finished piece
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade