Replacing Carbon Brushes; After Use - Makita LS1030N Instruction Manual

3
1. Triangular rule
2. Grip
3. Guide fence
1. Limit mark
1
1. Screwdriver
2. Brush holder cap
Lower the handle fully and lock it in the lowered position
001780
by pushing in the stopper pin. Square the side of the
1
blade with the face of the guide fence using a triangular
rule, try-square, etc. Then securely tighten the hex bolts
on the guide fence in the order from the right side.
2

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out
001772
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
After replacing brushes, plug in the tool and break in brushes
by running tool with no load for about 10 minutes. Then
check the tool while running and electric brake operation
2
when releasing the switch trigger. If electric brake is not
working well, ask your local Makita service center for repair.

After use

• After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding
portions with machine oil to prevent rust.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
19