Advertisement
VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY t o the user
-
as well as damage t o
the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with
voltage less than the nameplate rating is harmful t o the motor.
ADDITIONAL SAFETY RULES
1. Avoid cutting nails. Inspect for and remove all nails from the workpiece before
2.
Don't cut hollow pipe.
3.
Do not cut oversize workpiece.
4. Check for the proper clearance beneath the workpiece before cutting so that
5. Hold the tool firmly.
6.
Make sure the blade is not contacting the workpiece before the switch is
7. Keep hands away from moving parts.
8.
When cutting through walls, floors or wherever "live" electrical wires may
be encountered, DO NOT TOUCH ANY METAL PARTS
OF
THE TOOL!
Hold the tool only by the insulated grasping surfaces to prevent electric shock
if you cut through a "live" wire.
operation.
the blade will not strike the floor, workbench, etc.
turned on.
9.
Do not leave the tool running. Operate the tool only when hand-held.
IO.
Always switch off and wait for the blade t o come t o a complete stop before
11. Do not touch the blade or the workpiece immediately after operation; they
removing the blade from the workpiece.
may be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
4
Advertisement
