Dryercare - Maytag YMED8100DC0 Use & Care Manual

DRYERCARE
'- LEANING THE DRYER LOCATION
l Keep dryer a reaclear a ndfreefromitems thatwould block the [
air flow for proper dryer operation, This includes clearing piles
1
of laundry in front of the dryer.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (460 ram) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
CLEANING THE DRYER iNTERiOR
To
1.
clean dryer drum
Use a mild hand dish detergent mixed at a low
concentration with very warm water, and rub with
a soft cloth,
2. Rinse well with a wet sponge or towel,
3. Tumble a load of clean clothes or towels to dry drum
OR
Use a microfiber cloth and hot water in a spray bottle
to clean the drum and a second microfiber towel to dry.
NOTE: Garments that contain unstable dyes, such as denim
blue jeans or brightly colored cotton items, may discolor the
rear of the dryer interior. These stains are not harmful to your
dryer and will not stain future loads of clothes, Dry unstable
dye items inside out to avoid transfer of dye,
REMOVING ACCUMULATED LiNT
From inside the Dryer Cabinet
Lint should be removed every 2 years, or more often,
depending on dryer usage, Cleaning should be done by a
qualified appliance servicer,
From the Exhaust Vent
Lint should be removed every 2 years, or more often,
depending on dryer usage,
CLEANING THE LiNT SCREEN
Every load cleaning
The lint screen is located in the door opening of the dryer,
The control panel has an indicator light to remind you to clean
the lint screen after each load, A screen blocked by lint can
increase drying time,
To clean:
1. Pull the lint screen straight up, Roll lint off the screen with
your fingers, Do not rinse or wash screen to remove lint.
Wet lint is hard to remove,
2. Push the lint screen firmly back into place,
IMPORTANT:
m Do not run the dryer with the lint screen loose, damaged,
blocked, or missing, Doing so can cause overheating and
damage to both the dryer and fabrics,
m if lint falls off the screen into the dryer during removal,
check the exhaust hood and remove the lint. See "Venting
Requirements" in the installation instructions,
As needed cleaning
Laundry detergent and fabric softener residue can build up
on the lint screen, This buildup can cause longer drying times
for your clothes, or cause the dryer to stop before your load is
completely dry. The screen is probably clogged if lint falls off
while the screen is in the dryer,
Clean the lint screen with a nylon brush every 6 months,
or more frequently, if it becomes clogged due to a residue
buildup,
To wash:
1. Roll lint off the screen with your fingers,
2. Wet both sides of lint screen with hot water,
3. Wet a nylon brush with hot water and liquid detergent.
Scrub lint screen with the brush to remove residue buildup,
4. Rinse screen with hot water,
5. Thoroughly dry lint screen with a clean towel,
Reinstall screen in dryer,
13