Connecting Drain And Electrical; Cable Tie - Frigidaire FFTW1001PW0 Installation Instructions Manual

Connecting drain and electrical
I Form a "U" shape on the end of the drain hose
with the hose pointed toward the drain, Place the
formed end in a laundry tub or a standpipe and
secure with a cable tie provided in the enclosure
package,
2 Place the hook end of the drain hose in the drain
opening, Secure the drain hose with the cable
tie (provided in the enclosure package) to the
standpipe, inlet hose, laundry tub, etc. so the hose
does not pull out from the force of the water.
The standpipe inside diameter must be 1-1/4" (3,2 cm)
minimum. There must be an air gap around the drain
hose in the standpipe, A snug hose fit can cause a
s!ph°n!ng acti°n: .........................................................................................................................
CABLE TIE
I
Check to ensure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet,
3 Plug the power cord into a grounded outlet.
Power cord with
3--prong grounded plug
4 Turn on the power at the circuit breaker/fuse box.
5 Carefully slide the washer to its final position,
Recheck for level and rock corners for stability.
6 Read the Use & Care Guide provided with the
washer, It contains valuable and helpful information
that will save you time and money.
7 Run the washer through a complete cycle, checking
for water leaks and proper operation,
8 If you have any questions during initial operation,
please review the "Avoid Service Checklist" in your
Use & Care Guide before calling for service,
9 Place these instructions in a location near the
appliance for future reference,