Problems And Warning Signals - ELNA eXcellence 680 Instruction Manual

Problems and Warning Signals

If a buzzer sounds and the LCD screen shows a warning sign, follow the guidance below.
Warning Sign Cause
1. The start/stop button is pressed with the foot control
connected.
2. The foot control is out of order.
(The foot control sign keeps blinking.)
The machine is started without lowering the presser foot.
The machine will stop if the presser foot is raised while
sewing.
The bobbin winder spindle is shifted to the right.
The machine will stop if the buttonhole is sewn without
lowering the buttonhole lever.
The twin needle key is pressed when a pattern unsuitable
for twin needle sewing has been selected.
The twin needle key is pressed when the twin needle sign
is indicated on the LCD screen.
The machine is started without lowering the feed dog with
button sewing selected.
The machine is started with the feed dog lowered.
The machine is started without the needle plate.
The machine is started when the needle plate for straight
stitch is attached and a pattern that cannot be used for the
needle plate has been selected.
The machine is started after halting due to overload.
89
Try this
Disconnect the foot control.
Contact the service center
or the store from whom the
machine was purchased.
Lower the presser foot and
start the machine.
Lower the presser foot and
start the machine again.
Shift the bobbin winder
spindle to the left for
stitching.
Lower the buttonhole lever
and start the machine again.
Select the pattern suitable
for twin needle sewing.
Replace the twin needle with
a single needle and press
the twin needle key.
Lower the feed dog.
Raise the feed dog.
Attach the needle plate.
Replace the needle plate.
Wait for at least 15 seconds
to restart. Remove tangled
threads around take-up lever,
hook race and automatic
thread cutting mechanism.
Do not lower the feed dog,
raise presser foot or shift
bobbin winder spindle while
the machine is running.