Built-In Needle Threader - ELNA eXcellence 680 Instruction Manual

z
q
w
x
r
c
y
v
e
t
23

Built-in Needle Threader

NOTE:
• The needle threader can be used with a #11 to #16
needle.
Thread size 50 to 90 is recommended.
• The needle threader cannot be used with the twin
needle.
CAUTION:
Always make sure to press the lockout key to lockout
the machine or turn the power switch off before using
the built-in needle threader.
z Turn the power switch ON.
Press the needle up/down button to raise the needle.
Press the lockout key to lock the machine.
Pull down the needle threader knob as far as it will go.
The threader hook comes out through the needle eye
from behind.
q Needle up/down button
w Threader knob
e Threader hook
x Draw the thread from left to right, under the left guide,
threader hook and right guide.
Draw the thread around the right guide toward you.
r Left guide
t Right guide
c Raise the threader slowly so a loop of the thread is
pulled up through the needle eye.
y Threader loop
v Remove the thread end through the needle eye to the
rear.
NOTE:
The needle threader cannot be used with the twin
needle.