Metal Cutting; Dust Extraction - Makita 4323 Instruction Manual

1
1. Hose
1
1. Rip fence (Guide rule)
(4) Complete the cut in the normal manner.
Finishing edges
002767
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.

Metal cutting

Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear. The
underside of the workpiece can be greased instead of using
a coolant.

Dust extraction

002771
Clean cutting operations can be performed by connecting
this tool to a Makita vacuum cleaner. Insert the hose of the
vacuum cleaner into the hole at the rear of the tool. Lower
the dust cover before operation.
NOTE:
• Dust extraction cannot be performed when making bevel
cuts.
Rip fence (optional accessory)
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing accessories.
1. Straight cuts
002773
When repeatedly cutting widths of 160 mm (6 - 9/32") or
less, use of the rip fence will assure fast, clean, straight
cuts.
11