GE GTH18GBDHRWW Owner's Manual And Installation Instructions page 14

Installation Instructions
REVERSING THE DOOR SWING (CONT.)
[] REVERSING THE DOOR HANDLES(CONT.)
5.4
Transfer Freezer Door Handle
5.4.1 Remove the screw
holding the handle
to the top of the
door and the two
screws holding the
handle to the bottom
of the door,
5.4.2 Remove the handle,
5.4.3
Remove the screw from the
right top edge of the door
and insert it into the handle
screw hole on the leR side,
5.4.5
Attach the handle to the
right edge of the door with
screws at top and bottom,
using bottom holes vacated
by removal of the door stop
screws,
[g] RE-HANGING THE DOORS
6.1 Re-hang the fresh food door
6.1.1 Lower the fresh food door onto the
bottom hinge pin, Be sure the washer
is in place on the pin.
Plastic
Washer
Hinge==-_o"
Bracket Ui_ _
[g] RE-HANGING THE DOORS
(CONT.)
6.1.2
Insert the pin on the center hinge into the socket in the
top of the door, Place the spacer, then the washer, on
the hinge pin, Pin
NOTE: The center hinge must
be turned over as shown when
mounted on the left side,
and Spacer
6.1.3 Tilt the door toward the cabinet, As the door is brought
into position, slide the hinge under the head of the screw
which earlier had been partl}/driven into the outermost
hole, Insert the remaining screw, then tighten both
screws securel}/,
6.2 Re-hang the freezer door
6.2.1 Lower the freezer door _ /
onto the center
Cente_
Oe,. e''As IL
the washer and Pin ____ ._ ._
spacer are in place
on the
pin. _....
and Spacer
6.2.2 Tilt the door toward the cabinet, lifting the top hinge so
the pin fits into the socket on the top of the door.
6.2.3.
Make sure the door is slightl}/above the top of the
cabinet and the gap between the doors is even
across the front, Tighten the top hinge screws, Do not
overtighten these screws-tighten them until the}/are
.just snug, then turn them another one-half turn,
14