To Remove The Freezer Top Hinge Cover; To Remove The Freezer Door; Non-Adjusting Hinge - Frigidaire FFHS2622MSS Use & Care Manual

Remove the two bottom hinge screws and
hinge i fnecessary.
Hinge
3 Detach the water tube from the connector
located below t he freezer door. The
connector releases when y ou press its
outer sleeve inward.
4 Remove the screws from the top hinge
and pull t he multi-wire cable through it.
Lift t he door offofthebottom h inge.
5 Remove the two bottom h inge s crews and
hinge ifnecessary,
ToDisconnect
1.Press o uter ring against fac eof
fitting
Adjustable Hinge
To reinstall the refrigerator door, reverse the
above steps.
To remove the freezer top hinge
cover:
1 Remove the two screws from each cover
over the top door hinges.
2 Lift hinge cover straight up and off,
Front Rear
Cover Screws Cover
Screw
Top Hinge
Cover
Hi_
Multi-Wire
Cable - //
remove tube
To Connect
Insert tube and push until mark
touches face of fitting
; Door
"_,_.H_nge/ Assembtv Screws
Adjustable Hinge (some models)
Door
To remove the freezer door:
1 Detach the multi-wire cable connector
located above the top hinge, Grasp both
sides of the connector firmly and pull apart.
2 Trace lightly around the hinge with a
pencil. This makes reinstallation easier.
, Line
! Tubing
H nge
Assembly Screws
Non-Adjusting Hinge (some models)
6 Lay the door on its side to avoid damage
to the water tube extending from the
bottom hinge.
To reinstall the freezer door, reverse the above
steps,
Be sure doors are set aside in a secure position
where they cannot fall and cause personal injury.