Installation Requirements; Tools And Parts - Maytag YMEDB725CG0 Installation Instructions Manual

INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed for all installations:
Tools needed for gas installations:
Flat-blade screwdriver
Level
Utility knife
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Vent clamps
Caulking gun and compound
(for installing new exhaust vent)
8" (203 mm) or 10"
(254 mm) pipe wrench
8" (203 mm) or 10"
(254 mm) adjustable wrench
(for gas connections)
Pipe-joint compound
resistant to LP gas
Parts supplied {all models):
Leveling legs (4) for models
with riser
Leveling legs (4) for models
without riser
Parts supplied {steam models):
&
"Y" connector
2' (0.6 m) inlet hose
Tin snips (new vent
installations)
Tape measure
1/4"( 6 mm) nut driver
(recommended)
Pliers
5' (1.52 m) Net Hose Rubber washer
Remove parts package from dryer drum. Check that all parts
are included.
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the "Assistance
or Service" section in your "Use and Care Guide."
Optional Equipment: (Not supplied with dryer)
Refer to your "Use and Care Guide" for information about
accessories available for your dryer.
4