Dishwasher
Installation
STEP 5: INSTALL 90 ° ELBOW
, Thread 3/4" GHT 90°
elbow onto water valve.
Ensure rubber gasket is
located between valve
and elbow,
Water Valve
Bracket
, Do not overtighten
\
elbow. Water valve
bracket could bend or
water valve fitting could
break.
, Position the end of the
elbow to face the rear of
the dishwasher.
Figure K
Front of dishwasher
90 ° 3/4"
GHT Elbow
Fill Hose
STEP 7: POSITION WATER LINE
AND HOUSE WIRING
, Position water supply line and house wiring on the floor of
the opening to avoid interference with base of dishwasher
and components under dishwasher.
Line
Wiring
STEP 6: INSTALL DRAIN HOSE TO DRAIN
LOOP
Connect drain loop end to drain hose using the screw clamp
as shown in the figure.
Figure L
Figure M
STEP 8: INSTALL DRAIN
HOSE,
THROUGH
CABINET
, Position dishwasher in front of cabinet opening. Insert drain
hose into the hole in cabinet side. If a power cord is used,
guide the end through a separate cabinet opening.
i
J
Insulation
Blanket
f
Line
/
Ensure drain hose is not
twisted or pinched
Maximum drain hose
length is 15'
Do not disconnect or remove high
drain loop from left side of dishwasher
Figure N
Tip: Prevent unnecessary service call charges for fill, drain
or noise concerns.
Position utility lines so they do not interfere with anything
under or behind the dishwasher.