Advertisement
Available languages
Available languages
Dishwasher
Installation
STEP 16: CONNECT DRAIN LINE
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
. Determine size of inlet port.
. Cut drain hose connector on the marked line, if required,
to fit the inlet port.
Figure W
Cutting Line
/
,s/8 3
/
IMPORTANT: Do not cut corrugated
portion of hose
. If a longer drain hose is required and you did not purchase
drain hose WD24×10065, add up to 66" length for a total of
14/4"(12 feet) to the factory-installed hose. Use 5/8" or 7/8"
inside diameter hose and a coupler to connect
the 2 hose ends.
Secure the
connection
_
with hose
clamps.
Figure ×
Hose Clamp
Hose Clamp
Coupler
NOTES:
. DRAIN CONNECTION HEIGHT IS NOTTO EXCEED 72" ABOVE
BOTTOM OF DISHWASHER.
. TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 12 FEET FOR
PROPER DRAIN OPERATION.
. Connect drain line to air gap, waste tee or disposer
using the previously determined method. Secure hose
with a screw-type clamp.
Method 1 - Air gap with waste tee or disposer
Waste Tee Installation
Figure Y
Disposer Installation
Method 2 - "High drain loop" with waste tee or disposer
With this method you will need the drain hose hanger set aside
in Step 1.
Fasten drain hose to underside of countertop with the provided
hanger.
__
Drain Hose Hunger
WasteTeeInstallation
Figure
Z
Disposer Installation
IMPORTANT
-
When connecting drain line to
disposer, check to be sure that drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF PLUGIS LEFTIN PLACE.
4
Remove
Drain
Plug
Tip: Avoid unnecessary service call charges for a no drain
complaint.
Make sure excess drain hose has been pulled through
the cabinet opening. This will prevent excess hose in the
dishwasher cavity from becoming kinked or crushed by the
dishwasher.
12
Advertisement
