GE GDT550HGD4WW Installation Instructions Manual page 4

Installation Preparation
PREPARE ELECTRICAL WIRING
WARNING:
FOR PERSONAL SAFETY: Removehousefuse or open circuit breaker
beforebeginning installation.Do not usean extensioncord or
adapter plug with this appliance.
],
Receptacle \
. I \
Location in Adjacent _ ,,
%
ADVERTENCIA:
PARA SEGURIDAD P ERSONAL: Quite el fusible o abra el interruptor
de circuitos antes de comenzarla instalaci6n.No utilice un cable
de extensi6no un enchufe adaptador con este artefacto.
Electrical Requirements
, This appliance must be supplied with !20V, 60 Hz., and
connected to an individual properly grounded branch circuit,
protected by a 15- or 20-ampere circuit breaker or time-delay
fuse.
, Wiring must be 2 wire with ground and rated for 75°C(176%).
, If the electrical supply does not meet the above requirements,
call a licensed electrician before proceeding.
Grounding Instructions-Permanent Connection
This appliance must be connected to a grounded metal,
permanent wiring system, or an equipment-grounding
conductor must be run with the circuit conductors and be
connected to the equipment-grounding terminal or lead on
the appliance.
Grounding Instructions-Power Cord Models
This appliance must be grounded. In the event of a malfunction
or breakdown, grounding will reduce the risk of electric shock
by providing a path of least resistance for electric current.
This appliance is equipped with a cord having an equipment-
grounding conductor and a grounding plug. The plug must
be plugged into an appropriate outlet that is installed and
grounded in accordance with all local codes and ordinances.
AWARNING:
Theimproper connectionof the equipment grounding conductor
can result in a risk of electric shock.Checkwith a qualified
electrician or servicerepresentativeif you are in doubt that
the applianceis properlygrounded.
Cabinet
Figure E
White
For models equipped with power cord: Do not modify the plug
provided with the appliance; if it will not fit the outlet, have a
proper outlet installed by a qualified technician.
Cabinet Preparation & Wire Routing
, The wiring may enter the opening from either side, rear or the
floor within the shaded area illustrated above in Figure E and
defined in Figure A.
, Cut a 1-1/2" maximum diameter hole to admit the electrical
cable. Edges of hole should be smooth and rounded.
Permanent wiring connections may pass through the same
hole as the drain hose and hot water line, if convenient. If
cabinet wall is metal, the hole edge must be covered with a
bushing.
NOTE: Power cords with plug must pass through a separate
hole.
Electrical Connection to Dishwasher
Electrical connection is on the right front of dishwasher.
, For permanent connections the cable must be routed as
shown in Figure E.Cable must extend a minimum of 24" from
the rear wall.
, For power cord connections, install a 3-prong grounding
type receptacle in the sink cabinet rear wall, 6" min. or 18"
maximum from the opening, 6" to 18" above the floor.
, Use only W×09×70910 or W×09×70911 Dishwasher Power
Cord Kit.
A ADVERTENCIA:
La conexi6ninadecuadadel conductorde conexi6na tierradel
equipamientopuedeprovocarun riesgode descarga el_ctrica.
Consultea un electricistacalificadoo representante de servicio
t_cnicosi tienedudassabrela correctaconexi6na tierra del aparato.