GE GDT550HGD4WW Installation Instructions Manual page 14

Dishwasher Installation
STEP 19: DISHWASHER WET TEST
.Turn on power supply or plug power cord into outlet,
if equipped.
. Select u cycle to run and push the Start/Reset pad.
. Ensure the door is latched. Dishwasher should start.
. Check to be sure that water enters the dishwasher. If water
does not enter the dishwasher, check to be sure that water
and power are turned on.
. Check for leaks under the dishwasher. If a leak is found, turn
off power at the breaker, and then tighten water connections.
Restore power after leak is corrected.
. Check for leaks around the door. A leak around the door could
be caused by door rubbing or hitting against
adjacent cabinets. Reposition the dishwasher if necessary.
See Step 12.
. Press end hold the Start/Reset pad for 3 seconds to cancel
the cycle. The unit will begin to drain. Check drain lines. If
leeks ere found, turn off power at the breaker end correct
plumbing us necessary. Restore power after corrections ere
made. See Steps 6, 7, 8, 9 end 16.
. Open dishwasher door and make sure oil of the water has
drained. If not, check that disposer plug has been removed
end/or air gap is not plugged. Also check drain hose to be
sure it is not kinked underneath or behind dishwasher. See
Step 16.
. Press Start/Reset pad once again end run dishwasher
through another cycle. Check for leeks end correct if
required.
. Repeat this step us necessary.
STEP 20: POSITION SOUND BARRIER
AND INSULATION
Ion some models}
Skip this step if the sound barrier is not assembled to the
dishwasher.
. Locate the sound insulation package inside the dishwasher.
. Locate the control box.
Control
Box
. Peel off the paper from the insulation.
. Apply the insulation to the underside of the control box and
flush with its front face as shown.
Insulation shown adhered to bottom edge of the control
box, flush with the front face, and correctly placed along
dishwasher bottom.
14