Step 4, Connect Power; Step 5, Install Filters, Check Operation; Cleaning - GE ZVB30ST4SS Installation Instructions Manual

Installation instructions
r4-] CONNECT POWER
Plug power cord into properlg grounded receptacle.
rs] INSTALL FILTERS, CHECK OPERATION
• Press the ON/OFF pad on the control
to raise the vent.
• Slip fingers into the vent holes. Lift the vent
straight up and pull forward.
Retainers
Filter Tabs
• Slide filter into the retainers Grid close the vent.
o Press the Fan Speed HIGHER pad to start the
blower. Adjust the blower bg pressing HIGHER or
LOWER.
, To lower the vent, press the ON/OFF pad.
NOTE: It is not necessorg to turn the fan OFF
before lowering the vent. The fan will automaticallg
turn off when the vent is lowered. When the fan
is not turned off before lowering the vent, it will
automaticallg come on at the previouslg set speed
when the vent is fullg raised.
IMPORTANT: The vent can be activated bg pressing
the pads on the switch. Do not use excessive force
or sharp objects to activate the switch. Damage
could occur and void the warrantg.
13