Positioning; Reversing The Door Of Your Appliance - Haier HBR-1301AA User Manual

The green and yellow wire must be connected to the terminal
marked "E" (earth), or by the earth symbol, or coloured green
and yellow.
o When the connection is completed, no stray strands or cut wire
should be present. The cord clamp must be secured over the
outer sheath.

Positioning

o It is advisable that your appliance is only installed in a location
where the ambient temperature of the room, corresponds with
the climate classification that is stated on the rating plate of your
appliance. Your appliance may not function correctly if the
ambient temperature falls outside of the following ranges.
Climate classification Appropriate ambient temperature
SN
N
ST
o Your appliance should not be located in direct sunlight or
exposed to continuous heat or extremes of temperature (e.g.
next to a radiator or boiler).
o The door should be able to open completely and freely.
o The appliance should be situated so you can easily access the
food that is stored in it.
o You should check whether there is an electrical socket available,
which will be accessible after your appliance is installed.

Reversing the door of your appliance

This procedure MUST be completed before the furniture
door is attached.
Any parts that you remove from the appliance whilst
reversing the door, should be retained for later use.
WARNING- Take care when opening the hinges, they
are sprung loaded and there is the risk of injury if
they close on your hand.
+10 to +32 degrees centigrade
+16 to +32 degrees centigrade
+16 to +38 degrees centigrade
17