GE PGP990 Owner's Manual & Installation Instructions page 28

Installatidff°l tructions
INSTALLTHE COOKTOP
[]
INSTALL THE COOKTOP
Lower the cooktop into the countertop opening,
guiding it into position.
[] SECURE THE COOKTOP
Tighten the tie-down bolts to secure the cooktop
to the counter. For countertops less than 1" thick,
securely attach filler blocks of wood to the bottom
of the countertop where the tie-down bolts will be
tightened.
Countertop _4,
lo,I
!
Filler wood block Tie-down
for countertops bolt through
less than l< thick cooktop tab
[]
OPTIONAL: ATTACH A BLOWER
TRANSITION DUCT
If using 6" round standard ductwork, attach a
blower transition duct. This 3½" x 10" rectangle to
6" round transition duct is available at your local
building supply store.
Install the transition duct to the blower outlet.
Secure all joints with duct tape to assure an
airtight seal.
Screw (on
other side)
CONNECT THE DUCTWORK
Connect the ductwork prepared earlier to the
blower transition duct.
[_] ELECTRICAL CONNECTION
Electrical requirements:
120-volt, 60-Hertz, individual, properly grounded
branch circuit protected by a 15-amp circuit
breaker or time-delay fuse.
GROUNDING
IMPORTANT: (Please read carefully.)
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
The power cord of this appliance is equipped with
a three-prong (grounding) plug which mates with
a standard three-prong grounding wall receptacle
to minimize the possibility of electric shock hazard
from this appliance, The customer should have
the wall receptacle and circuit checked by a
qualified electrician to make sure the receptacle is
properly grounded and has correct polarity.
Where a standard two-prong wall receptacle is
encountered, it is the personal responsibility and
obligation of the customer to have it replaced
with a properly grounded three-prong wall
receptacle in accordance with the National
Electrical Code.
Do Not, Under Any Circumstances, Cut Or
Remove The Third (Ground) Prong From The
Power Cord.
Do not use an extension cord with this appliance.
Plug the power cord into an approved wall outlet.
28