Craftsman 580.988390 Operator's Manual page 8

AssembleHose Reel
When performing the following assembly procedures, pay
close attention to the illustration at the bottom of this page.
NOTICE The handle is shown removed from the unit for
clarity.
1. Assemble both halves of hose reel (A) and secure using
four screws.
2. Slide handle (B) intohexagon hole of hose reel and
secure using one screw.
3. Place hose reel assembly (C) into slots of handle (D).
4. Place large retainer (E) on right side of hose reel shaft as
shown, and secure using two screws. Placesmall retainer
(F) on left side of hose reel shaft as shown, and secure
using two screws.
5. insert one end of high pressure hose (6) into opening of
hose reel (H).
6. Turn handle to wind hose around hose reel (J).
%