MASSEY FERGUSON MF 135 Operator's Manual page 65

REMOVING TRACTOR FROM STORAGE
1. Install fully charged battery. This is
a negative ground electrical system.
2. Fill fuel tank with clean, high quality
fuel.
3. Check oil level in engine crankcase
and transmission.
4. Remove coverings from exhaust pipe
and air filter inlet.
5. Check tightness of all nuts, bolts and
screws; tighten as necessary.
6. Lubricate all grease fittings with the
proper type and quality of pressure gun
grease (See ''Lubrication'' section).
7. On diesel models, "air-bleed" the
fuel system (see "Servicing" section).
8. Start Tractor and allow it to run for
10 to 15 minutes. Observe all instruments,
paying particular attention to the ammeter,
oil pressure gauge and temperature gauge.
9. Drive Tractor without load, at slow
speeds, noting the instruments and general
operation.
- 56 -