Advertisement
3. Installation
Before you connect the modem, you must have an available Ethernet card (either 10Base-T
or set to run at 10 Megabits per second) installed in your computer. Refer to the Ethernet
card manufacturer's instructions for installing and configuring your Ethernet card. See the
Appendix in this guide to make sure you have an Ethernet card installed.
Connecting the Westell ADSL Modem
Refer to the diagram and easy step-by-step instructions below for connecting your ADSL modem.
Verify that you have an available Ethernet card, either 10Base-T or configured to 10 Megabits per
1
second, installed in your computer. If you do not know how to check, see the Appendix.
Plug the power supply cord into your electrical outlet and connect the other end to the round connector
2
on the back of the modem (
Connect the DSL Modem phone cord to the
3
DSL Modem phone cord in your Accessories box.
Connect the other end of the DSL modem phone cord to a phone jack on the wall (or the 2-for-1
4
adapter).
IMPORTANT:
cord to the ADSL jack on the DSL filter used for wall phones.)
Connect the Ethernet cable to the Ethernet card in your computer and to the
5
of the modem (
6
Turn the modem
-
The
Power
-
The
Ready
might take a minute or two.
-
The
Power
If the Power, Ready, and Link lights are all steady green, your modem is connected, on, and ready. (The
Activity light illuminates only when you send or receive data.) The following section tells you more about the
modem indicator lights.
If you experience any problems, please contact
). Do not force the connector—it only fits one way.
#1
Do Not use a DSL filter on this connection. (Exception: you can connect this
).
#3
(on is I, off is O) and wait for the Power, Ready, and Link lights to turn green.
ON
light illuminates to a steady green immediately.
light flashes while the DSL modem synchronizes with Verizon's central office which
,
and
lights illuminate to a steady green when the modem is synchronized.
Ready
Link
IMPORTANT
jack on the back of the modem (
LINE
Verizon DSL Technical Support
3
). You must use the
#2
jack on the back
ETHERNET
at
.
1-800-567-6789
030-300108D
Advertisement
