Download Print this page

Craftsman 137.415020 Operator's Manual page 6

Hide thumbs Also See for 137.415020:

Advertisement

11
.WEAR PROPER APPAREL. Do
not wear loose clothing, gloves,
neckties, rings, bracelets or other
jewelry which may get caught in
moving parts. Nonslip footwear is
recommended. Wear protective hair
covering to contain long hair.
12. ,d_l_ _
ALWAYS WEAR EYE
U
PROTECTION. Any
power tool could throw
foreign objects into the eyes and
cause permanent eye damage.
ALWAYS wear Safety Goggles (not
glasses) that comply with ANSI
Safety standard Z87.1. Everyday
eyeglasses have only impact-
resistant lenses. They ARE NOT
safety glasses. Safety Goggles are
available at Sears. NOTE: Glasses
or goggles not in compliance with
ANSI Z87.1 could cause serious
injury when they break.
13.
WEAR A FACE MASK
OR DUST MASK. Sawing
operation produces dust.
14.@
SECURE THE
WORKPIECE.
Use
clamps or a vise to hold
workpiece when practical. It is safer
than using your hand and also it
frees both hands to operate the tool.
15.DISCONNECT
TOOLS FROM
POWER SOURCE before servicing,
and when changing accessories
such as blades, bits and cutters.
16.REDUCE THE RISK OF
UNINTENTIONAL
STARTING.
Make sure switch is in the OFF
position before plugging the tool in.
17.USE RECOMMENDED
ACCESSORIES.
Consult
this Operator's Manual for
recommended accessories. The use
of improper accessories may cause
risk of injury to yourself or others.
18.NEVER STAND ON THE TOOL,
Serious injury could occur if the
tool is tipped or if the cutting tool is
unintentionally
contacted.
19.CHECK FOR DAMAGED
PARTS.
Before further use of the tool, a
guard or other part that is damaged
should be carefully checked to
determine that it will operate
properly and perform its intended
function - check for alignment of
moving parts, binding of moving
parts, breakage of parts, mounting
and any other conditions that may
affect its operation. A guard or other
part that is damaged should be
properly repaired or replaced.
20.NEVER LEAVE THE TOOL
RUNNING UNATTENDED. TURN
THE POWER "OFF". Do not walk
away from a running tool until the
blade complete stop and the tool is
unplugged from the power source.

Advertisement

loading