Advertisement
MOUNTING TABLE SAW TO STAND
(FIG. E)
1. Lift the saw body (1) and place
on the stand (2), aligning the four
mounting holes (3) of the saw base
with the four mounting holes (4) on
the top plate of stand.
2. Attach the table saw to the stand
with four hex head bolts (5) and
washers (6).
3. Tighten all mounting bolts with a
13 mm wrench.
[A wARNING
]
Do not overtighten the four bolts as
this may cause damage to the base of
the saw.
Fig. E
5
,.6
3
4
4. Place the stand on a level surface
and adjust the stand adjustment
knob (7) located on the left front
stand leg. Adjust until all legs are
contacting the floor and are at a
similar angle to the floor.
NOTE: Before using the saw, verify
that the table saw is securely locked
in position, and that the left front stand
adjustment knob has stabilized the
table saw.
2. Rotate the hook (1) to the stop screw
to secure the legs of the stand in
position. (Fig. B)
3. Rest the right side of the saw onto
the floor.
4. Fold the left side leg set (3) close
to the base by releasing the two left
side locking levers (2) from slot B to
slot A. (Fig. B)
5. Fold the stand slowly downward as
shown in Fig. F.
UNFOLDING THE STAND
1. Repeat steps 1 to 3 in the section
"SETTING UP THE STAND".
2. Lift the right side of stand slowly by
grip the extension table hand hold
upward to its highest position, the
locking handle (5) will rebound to left
automatically to secure the stand.
TRANSPORTING
THE SAW
(FIG. B, C, F)
1. Repeat steps 1 to 3 in the section
"FOLDING THE STAND".
2. Unfold the left side leg set (3) by
releasing the two left side locking
levers (2) from slot B to slot C.
(Fig. B)
3. Move the saw to the desired location
for operation or store the saw in a
dry environment by using the left
side leg set (3) as handle. (Fig. B)
Fig. F
store
FOLDING THE STAND (FIG. B, C, F)
1. Lift the right side of table saw by
the handle slightly, raise the cover
plate (4) on the right side of stand,
pull the locking handle (5) right out
transportation
as the release direction, and then
move the saw slowly close to the
wheel (6). (Fig. C, F)
;_
20
Advertisement
