Advertisement
Blade guard (Fig. K)
The storage for the blade guard is
located on the right side of the stand.
1. Take the blade guard (1) and press
down on the red spring button (2)
located on the top.
2. Position the blade guard (1) and
align the slot (3) over the set
plate (4).
3. Lower the blade guard (1) onto the
set plate (4), and release the red
spring button (2) so that two
latches (5) engage into two locking
hooks (6) completely.
Fig. K
1
Anti-kickback
pawls (Fig. L)
The storage for the anti-kickback
pawls
is located on the right side of the stand.
1. Take the anti-kickback
pawl (1) and
lift up the locking lever (2) located
ont he top.
2. Turn the anti-kickback pawls (1)
upside down to make the teeth point
upward as shown. Align the slot (3)
of anti-kickback
pawls to the slot (4)
on the set plate (5), move the anti-
kickback pawls (1) upward to secure
the entire assembly on the storage.
Press down on the locking lever (2).
Fig. L
2
Riving knife (Fig. M)
The storage for riving knife is located
on the right side of the stand, insert the
riving knife (1) into the bracket (2) as
shown in Fig. M.
Fig. M
Power cord (Fig. N)
Wrap the power cord (1) onto the
storage clamps (2) when saw is not
in use. This can prevent damage to
the cord. Do not wrap the power cord
around the dust port (3).
Advertisement
