Advertisement
5.Attached theC-clamps (5)tosecure
thefeatherboard totheedgeofthe
table,
Fig. SS
4
Fig. TT
c
3/8 in. thick plywood base
::I[
_ll_
21in
]
AUXILIARY
FENCE (FIG. TT)
Making the base:
o Start with a piece of 3/8 in. plywood
at least 5-1/2 in. wide or wider and
21 in. long or longer.
o Cut the piece to shape and size as
shown.
Making the side:
o Start with a piece of 3/4 in.
hardwood at least 1-3/4 in. wide or
wider and 21 in. long or longer.
o Cut the piece to shape and size as
shown.
Putting it together:
o Fasten the pieces together with glue
and woodscrews.
WARNING
1
Make sure the screw heads do
not stick out from the bottom
of
the base, they must be flush or
recessed.
The bottom
must be flat
and smooth
enough to rest on the
saw table without
rocking.
The edge must be
parallel with the face
PUSH BLOCK
Use for ripping operation when the
workpiece is too narrow to use a push
stick. Always use a push block for rip
widths less than 2 inches.
MAKE A PUSH BLOCK (FIG. UU)
Making the base:
o Start with a 3/8 in. plywood at least
5-1/2 in. wide or wider and 12 in.
long or longer.
o Cut the piece to shape and size as
shown.
Making the handle:
o Start with a 3/4 in. hardwood at least
5 in. wide or wider and 7 in. long or
longer.
o Cut the piece to shape and size as
shown.
Making the bracket:
o Start with a 3/8 in. wood at least
3/8 in. wide or wider and 2-1/2 in.
long or longer.
o Cut the piece to shape and size as
shown.
Putting
it together:
o Fasten the base and handle together
with glue and woodscrews.
Advertisement
