Advertisement
Available languages
Available languages
Fig. C
G
B
K
C
N
R
UNPACKING AND CHECKING
CONTENTS (Fig. C)
This Bench Grinder will require a minimal amount of
assembly. A 12mm x 10mm open end wrench is
provided for mounting the Tool Rest Assemblies and
the Spark Arrestor Assemblies.
1.
Remove parts from all of the cartons and lay them
on a clean work surface.
2.
Remove any protective materials and coatings from
all of the parts and the bench grinder. The protec-
tive coatings can be removed by spraying WD-40
on them and wiping it off with a soft cloth. This may
need to be redone several times before all of the
protective coatings are removed completely.
CAUTION:
DO NOT use acetone, gasoline or
lacquer thinner to remove any protective coatings.
3.
Compare the items to Figure C; verify that all items
are accounted for before discarding the shipping
box. If there are any missing parts, call Customer
Helpline 1-855-758-0015.
If any parts are missing, do not attempt to plug in the
power cord and turn "ON" the Bench Grinder. The
Bench Grinder can only be turned "ON" after all the
parts have been obtained and installed correctly.
The following items are to be provided in the shipping
box:
A.
Grinder (not shown)
B.
Eyeshield assembly (2)
C. Carriage head screw M6 x 12mm (2)
D. Hex head screw, M5 x 10 (4)
E.
Flat washer M5 (4)
F. Lock washer M5 (4)
G. Wheel dresser
H. Hex head screw M8 x 12mm (4)
I.
Flat washer M8 (4)
J.
Spark arrestor, left
K.
Spark arrestor, right
L.
Flat washer M6 (4)
M. Eyeshield knob (2)
N. Tool rest support, left
O. Tool rest support, right
P. Tool rest, right
Q. Drill bit sharpening plate
R. Tool rest knob (2)
S.
Spacer for wire wheel
T.
Tool rest, left
U. Special wrench
V.
Quench tray (not shown)
W. Lock Washer M6 (2)
Advertisement
