Craftsman 21154-3 Owner's Manual page 10

TheBench G rinder isprovided witha leftandright t wo
piece T ool R est. B oth Tool Rests have aflat, s mooth
surface t olayyour w orkpiece against. Anaccessory
Drill B itSharpening Plate isincluded. This plate goes
onover t heright T ool R est onlyandisused tosharpen
twist d rill b its.
1. DONOT assemble theBench G rinder until y ouare
sure thetool I SNOT plugged i n.
2. DONOT assemble theBench G rinder until youare
sure thepower switch isinthe"OFF" position.
3. DONOT assemble theBench G rinder until y ouare
sure thegrinding wheels a refirmly tightened tothe
Bench G rinder.
TOOL RESTS (Figs. D and E)
The Bench Grinder is provided with two different Tool
Rests assemblies. The Left Side Tool Rest is entirely
flat. The Right Side Tool Rest is also flat.
1,
Assemble the Tool Rest Supports (A) to the inside
surface of the Wheel Covers (B) with the flat
washers (C) and hex head screws (D) as shown.
See Figure D.
2. Assemble the Tool Rests (E) to the Supports (F)
with the flat washers (G) and Adjustment Knobs (H)
as shown. See Figure E.
3,
Adjust each Tool Rest until its inside edge (I) is
1/16" from the grinding wheel. Firmly tighten the
hex head screws holding the supports. See
Figure E.
Fig. D
Fig. E
E
H
G
4,
Install the Drill Bit Sharpening Plate by loosening
the Right Side Adjustment Knob until there is
approximately a 1/4" of threads visible. Place the
Plate onto the Right Side Tool Rest and over the
visible threads. The Flat Washer must be placed
between the Plate and the Adjustment Knob.
Tighten the Adjustment Knob. See Figure E
IMPORTANT: The Drill Bit Sharpening Plate should
ONLY be used when sharpening twist drill bits.
Fig. F
A
D
lO