Craftsman 21154-3 Owner's Manual page 11

SPARK ARRESTORS (Fig. G)
1,
Assemble the Spark Arrestors (A) to the inside
surface of the Wheel Covers (B) with the hex
head screws with washers (C) as shown.
See Figure G.
2. Adjust each Spark Arrestor until the lower edge (E)
is 1/16" from the grinding wheel. Firmly tighten the
hex head screws. See Figure G.
Fig. G
B
E
EYESHIELDS (Fig. H)
1,
Assemble the eyeshield (C) to the Spark Arrestor
(A) inserting carriage head screw (B) through
Eyeshield and the Spark Arrestor as shown.
See Figure H.
2. Assemble the flat washer (D), lock washer (F) and
Lock Knob (E) to the carriage head screw and tighten
until the Eyeshield remains in the desired position.
See Figure H.
B
Fig. H
D
E F
WORK LIGHT (Fig. J)
The Bench Grinder is provided with a Flexible Work
Light to assist in visibility of the workpiece.
The Bench Grinder is NOT provided with a light bulb for
the Flexible Work Light.
W!Ikvlv/_4 ;1_11_ [€!
To reduce the risk of fire, use a 120 volt, 40 Watt or less
Track Light Bulb, Type R20, medium base or equivalent
(not included). DO NOT use a light bulb that extends
past the end of the light housing.
The Flexible Work Light may be turned "ON" or "OFF"
by using the rotary switch (B) on the top surface of the
housing (A). The switch can be rotated in the clockwise
direction only. See Figure J.
NOTE: The Flexible Work Light can be turned "ON" or
"OFF" even if the Bench Grinder is turned "OFF".
CAUTION: The Flexible Work Light housing will remain
hot for a few minutes after turning it "OFF". Avoid con-
tact with housing until it is cool.
Fig. J
B
A
C
11