Advertisement
Available languages
Available languages
To avoid breakage: Do NOT handle or
manipulate the unit by the cooktop.
The counter-top
around
the cut-out
should
be flat and leveled
(see
hatched
area on illustration
1).
Before installing
the unit, measure
the heights of the two (2) cabinet
sides (HI-4),
front and back (see illustration
1 ) from the floor to the
top of the counter.
Level the range using the
leveling
legs or leveling device
so that the height from the
floor to the underside
of the
cooktop
frame is greater than
the tallest cabinet
measurement
by at least 1/16" (0,16 cm) (see
illustration
2).
Model e uqMjp_ped with levelincL
1 ½" Max.
(3,8 cm Mix. )
Shave Raised Edge
to Clear Space for
a 31½" (80 cm)
Wide Cooktop.
Illustration
1
device:
Remove
and discard
the two rear leveling
legs, they are only in place to
solidify the unit during the transport.
Slide the unit into the cabinet.
Make sure the center of the unit is aligned with the center
of the cabinet
cut-out.
Remove
the
protective
channels
on each
side
of cooktop
(if
equipped).
The metal flange
under each side of the cooktop
MUST be placed
over the cabinet
countertop
for proper
unit support.
The cooktop
should
NOT directly
touch the countertop
(see illustration
2) or
else it could cause damage
to the cooktop
voiding
the warranty.
Level the unit if
needed.
After the installation,
MAKE SURE
that the unit is
supported
by the
leveling
legs NOT
by the cooktop.
Illustration 2
.....
. • •.. • ,'"'"
j'
To
successfully
install the
range, the
initial level
height from
floor to
underside
of cooktop
frame should
be at least
1/16" (0,16
cm) taller than
cabinet sides
as measured
in step 2.
5
Advertisement
