Table of Contents
Advertisement
STEP 5:
INSTALL
THE MOUNTING PLATE
1. Remove the upper cabinet and wall templates.
NOTE: If you are venting the oven through the wall,
be sure you align the damper/connector
on the
rear of the mounting plate with the 3 1/4"x10"
duct. Be sure the damper moves freely.
See Figure 26.
2. Prepare the toggle bolts by attaching a spring toggle
head to the end of each toggle bolt as shown in
Figure 27.
3. Place the mounting plate against the wall and match
the screw holes. See Figure 28.
NOTE: Be sure to leave at least one walt-thickness
of
space between the head of the toggle bolt and
the spring toggle head so that the spring
toggle can open on the other side of the wall,
as shown in Figure 29.
4. Locate the stud holes (3/16") and insert the lag screws
through the mounting plate and into the holes.
See Figure 30.
5. Insert the toggle bolts through the dry wall holes (3/4").
Tighten the toggle bolts.
6. Slide washer onto lock pin and place inside upper
cabinet for future use as directed on the next page.
See Figure 31.
mounting plate
% Damper must be on top of
tab for proper venting.
Figure 26
spring
toggle head
mounting _
plate
toggle__J
Figure
27
I
support tabs
JL
II !S ................................
Figure 28
mounting pate
lag screw
")__
Figure
30
lock pin_,,,
washer
Figure
31
m14m
Advertisement
Table of Contents
