Table of Contents
Advertisement
YOUR SAFETY
FIRST
BEFORE
YOU START
e Proper
installation
is the installer's
responsibility!
- Read the entire manual before you begin. The Model number label is located on the oven front.
See Figure 1. Mounting plate is located on back side of microwave oven. See Figure 2.
BE SURE TO READ THE FOLLOWING
SAFETY
iNSTRUCTiONS:
Model Number Label
Mounting J
plate
(Remove from
oven to install.
Back of oven
Figure 1
Figure 2
WARNING
FOR YOUR SAFETY:
e You will need TWO people to install this oven. It is heavy and could cause personal injury if not handled
properly. The dimensions of the oven are as follows:
Height :16 7/16 inches
Width
: 29 15/16 inches
Depth
: 15 3/8 inches
Weight : 58 pounds
e Avoid
Electrical
Shock7
- Before you drill into the wall, note where electrical outlets are and where electrical wires might be behind
concealed the wall, YOU COULD GET AN ELECTRIC
SHOCK it you contact electrical wires with your
drill bit.
- Locate and disconnect the power of any electrical circuits that could be affected by installing this oven.
IF YOU DO NOT DISCONNECT
THE POWER, YOU COULD GET AN ELECTRIC SHOCK.
e ELECTRICAL
RATING OF THIS OVEN : 120V AC. 60Hz.
14 Amps / 1600 Watts (Microwave oven + Cooktop Lamps + Ventilation Fan)
- You need a 120V, 60Hz, AC only, 15A or 20A, fused electrical supply (located in the cabinet above the
microwave as close as possible to the microwave circuit) serving only the microwave.
Advertisement
Table of Contents
