Amana ADB1500ADS Instruction Manual page 8

Raises water temperature to improve cleaning for
loads containing tough, baked-on food.
Dries dishes with heat. This option, with the use of
rinse aid, will provide the best drying results.
Plastic items are less likely to deform when loaded
in the top rack. Use Heated Dry for optimum
drying performance or turn the Heated Dry option
off for air dry.
Turns the heating element on at the end of the
wash portion of the cycle. Its shorter heating time
uses significantly less energy compared to using
Heated Dry.
Runs dishwasher at a later time. Select a wash
cycle and options. Each time you press the delay
button it will display the next available delay time.
Press DELAY. Press START/RESUME. Close door
firmly.
NOTE: The dishwasher remembers the last Delay
you selected. To reset the delay time to something
other than what is displayed, continue to press the
Delay button until the desired delay time is
reached.
NOTE: Anytime the door is opened (such as, to
add a dish); START/RESUME must be pressed
again to resume delay countdown.
Control Lock Avoids unintended use of dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Control Lock, press and hold SANI RINSE for 3 seconds. Control Lock light will stay on for a short time,
indicating that it is activated. When the Lock indicator is lit all buttons are disabled. If you press any button while your
dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are
locked.
To turn off Control Lock, press and hold SANI RINSE for 3 seconds. Control Lock light turns off.
*Maximum Water added with any combination of options is 4.8 gallons (18.2L).
Control
8
OPTIONS
Purpose Comments
Press to start or resume If the door is opened during a cycle or the power is interrupted, the Start/Resume
a wash cycle. button LED flashes. Cycle will not resume until door is closed and START/
RESUME is pressed.
Press to cancel wash Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let
cycle. dishwasher drain completely.
To follow progress of your The Clean or Complete indicators will glow when a cycle is finished. (Depending
dishwasher cycle. on your model.)
NOTE: Indicators shown If you select the Sani Rinse option, when the cycle is finished, the "Sanitized"
are not available on all indicator glows. If your dishwasher did not properly sanitize your dishes, the light
models. flashes at the end of the cycle. This can happen if the cycle is interrupted, or
water could not be heated to required temperature. The light goes off when you
open and close the door or press CANCEL.
CAN BE WHAT IT DOES
SELECTED
WITH
SoilSense Raises the main wash
Heavy temperature to 135°F
Normal
(57°C)
Soak &
Prewash
SoilSense Uses a heating
Heavy element to speed
Normal
drying times. Heated
Dry option defaults to
1 Hour
On when any cycle is
Soak &
selected except for 1
Prewash
Hour Wash and Eco.
Available
with any
cycle
Available Delays start of a cycle up to 24 hours
with any
cycle
ADDED TIME ADDED
TO CYCLE WATER
GALLONS
(LITERS)
0:05 to 0:13 0 - 3.9
(0 - 14.6)
0:08 to 0:46 0
0:11 0
.