Tempo Fitness E902 Owner's Manual page 11

STEP 5
HARDWARE CONTENTS:
Wavy Washer (C) Hex Screw (D)
Φ8.5XΦ22XT1.5, 4 pcs M8x15, 4 pcs
Pedal Flat Washer (I) Pedal Arm Wavy Washer (J)
2 pcs Φ30xΦ20xT0.3, 2 pcs
D
C
LOWER HANDLEBAR
PEDAL ARM
I
G K
E J
STEP 6
HARDWARE CONTENTS:
Pedal Fixing Plate (L)
4 pcs
M
L
FOOT PLATE
20
Hex Screw (E) Spring Washer (G)
M8×20, 2 pcs Φ8, 2 pcs
Pedal Arm Sleeve (K)
2 pcs
A. Open hardware for step 5.
B. Connect Upper & Lower Handlebar left hand
side handlebars and fix in place using 2 Hex
Screws (D) and 2 Wavy Washers (C).
C. Once Handlebar assembly is secure, slide
1 Pedal Arm Sleeve (K) & 1 Pedal Arm
Wavy Washer (J) onto pedal arm axle, and
then slide on Pedal Arm, fix this in place
with 1 Hex Screw (E), 1 Spring Washer (G) &
1 Pedal Flat Washer (I).
D. Repeat steps B-C on the opposite side.
Pedal Bolt (M) Pedal Knob (N)
M6x52, 4 pcs 4 pcs
A. Open hardware for step 6.
B. Fixing Foot Plate, position Foot Plate in one
of three locations fixing in place with 1 Pedal
Bolt (M), Pedal Fixing Plate (L) and 1 Pedal
Knob (N).
C. Repeat step B on the opposite side.
N
STEP 7
HARDWARE CONTENTS:
Fix Handle Hex Screw (O) Fix Handle Wavy Washer (P)
M10 x 20, 2 pcs Φ10.5, 2 pcs
HAND PULSE
GRIP
O
P
CONSOLE MAST
STEP 8
HARDWARE CONTENTS:
PRE-ASSEMBLED SCREW
CONSOLE
A. Open hardware for step 7.
B. Carefully thread lower heart rate cable through
Console Mast opening and pull through top
of Console Mast. Fix handlebar to the Console
Mast using 2 Fix Handle Hex Screws (O) and
2 Fix Handle Wavy Washers (P).
A. Remove Pre-assembled Screws from Console.
B. Connect Upper Sensor Cable to Lower
Sensor Cable, then connect heart rate
Cable to the Console Cable.
C. Carefully tuck away all Cables in Console Mast
and fix Console in place with 4 Pre-assembled
Screws.
NOTE: All hardware are pre-assembled.
21