Panasonic PV-DV103-K Operating Instructions Manual page 56

Palmcorder
Table of Contents

Advertisement

Before Requesting Service
Tape Operations Caution
• When you go from function to function (PLAY, FF, REW etc.), please note that the unit
will not accept a new function operation until the previous operation is complete.
• The POWER Button and all function buttons, (PLAY, FF, REW, etc.) are only operational
after the tape has been completely loaded.
Lens Hood Area Operation Caution
When the following accessories are attached and the zoom is set to maximum wide angle,
the four corners of the sceen may appear darker:
• Wide or Telephoto conversion lens (optional).
• A filter (optional), etc. and then the lens hood.
• Two filters (optional).
If you have a problem with your Palmcorder, it may be something you can correct yourself.
Check the list below for symptoms and corrections.
Symptom
No picture in the EVF or LCD Monitor...
Video cassette cannot be inserted...
Video cassette cannot be removed...
No operation starts when operation
buttons are pressed...
Recording cannot be done...
Auto Focus does not operate...
Sound from microphone cannot be
monitored...
Sound cannot be heard...
56
DV103-K.p54-57.p65
Correction
• Make sure the Power Source is connected.
(pp. 14, 15)
• Make sure the POWER switch is set to VCR
or CAMERA. (pp. 18, 30)
• Check the Dew Indicator. (p. 57)
• Make sure the Battery is fully charged.
(p. 14)
• Make sure all necessary cables are
connected correctly and firmly. (p. 15)
• Make sure the Lens Cap is removed. (p. 18)
• Make sure the Power Source is connected.
(pp. 14, 15)
• Insert the cassette record tab up, window
side facing out. (p. 12)
• Make sure the Power source is connected.
(pp. 14, 15)
• Check the Dew Indicator. (p. 57)
• Make sure the record tab is closed. (p. 6)
• Check the Battery Indication. (p. 63)
• Make sure FOCUS is set to AUTO. (p. 27)
• Make sure the unit is ON and set to
CAMERA mode. (p. 18)
• Make sure the unit is set to REC or REC/
PAUSE mode. (p. 18)
• Make sure the Audio on the VCR MENU is
set to ST1. (pp. 43, 61)
56
2003/06/11, 13:19

Advertisement

Table of Contents
loading

Table of Contents