Error Message Codes - Vision Fitness T9200 SIMPLE Troubleshooting Manual

Troubleshooting: Treadmills

ERROR MESSAGE CODES

If an error occurs during auto-calibration of new console, an override of the error may be necessary. Cycle power,
press "STOP", then, on the speed key numeric press "5", "9", then "3".
E4 Incline position is outside the tolerances
E5 Elevation stall condition
E6 Signal from elevation is lost
E7 Speed time out error
E9 Signal from speed sensor is lost
If the wrong product is selected during initial set up a console reset can be done by holding down the "9" speed key
for 10 seconds.
Date of last revision: 11.06
4
TREADMILL.TROUBLESHOOTING.2007.REV1