How To Walk-Test The System - C&K systems Sierra S5030 Technical Manual

How to Walk-Test the System

A walk-test allows you to test
your system's functions without
causing an alarm. You should
conduct a walk-test once a
week.
The first step of a walk-test is
to place your system in walk-
test mode. Then, walk in front
of motion sensors, and open
protected doors and windows.
Each time a sensor detects
your presence, the keypad
6
beeps, and lights the LED of
the most recently faulted zone
in its display.
If your system fails to detect a
sensor, exit the walk-test mode
and make sure the sensor's
zone is not bypassed. (The
LED of a bypassed zone blinks
slowly.) If the zone is by-
passed, remove the bypass
and repeat the walk-test. If
your system still fails to detect
the sensor, contact your ser-
vice representative.
IMPORTANT: during a walk-
test, your building is not pro-
tected against actual alarms.
Technical Manuals Online! - http://www.tech-man.com
40
To Conduct a Walk-Test:
1. Press and hold the
[walk test] key for 2 seconds
until you hear two beeps.
Enter the master user code.
You see the following pattern
of lit zone LEDs:
2. Press the
3. Test your sensors by opening
protected doors and win-
dows, and by walking in front
of motion sensors. The key-
pad beeps twice each time
you open and close a pro-
tected door or window, or a
motion detector senses your
presence. The affected zone
LED lights.
4. When done, press the
key.
key.